Intelectron Motion Detector Security Light Manual
Manual mode only works at night because daylight returns the sensor to AUTO. Flip the light switch off for one second then back on to toggle between AUTO and MANUAL MODE. Manual mode works only with the ON-TIME switch in the 1, 5, or 20 position. Note: When first turned on wait about 1 1/ 2 minutes for the circuitry to calibrate. This industrial-grade motion lighting system offers a 60-foot detection area, and the motion detector senses 180 degrees side-to-side and 360 degrees up and down. This outdoor motion sensor light is powerful enough to protect big areas, plus the dual heads can be adjusted to cover two areas at once.
I am going to be installing one or two motion detector lights to cover my backyard. I would like the ability to 'override' the motion detector. What I mean by this is that I would like to be able to flip a switch that turns and keeps the lights turned on regardless of if there is motion or not.
Intelectron Motion Detector Manual
When the light switch gets turned off I would like the operation of the motion detector to return to normal. I first thought about just 'jumping' the motion detector with the switch, but I am concerned if the motion detector would be able to handle live power on both sides of its relay when the relay is turned off. Themes for sony vaio laptop windows 8. So my questions are, is it safe to do this 'jumping' method?
Intelectron Security Lights Instructions
If not are there any methods to do this or any common practices for this type of feature? Most motion detectors have a built-in override:. Normally the switch is kept on all the time. The motion detector monitors ambient light (daylight) and then activates when it's dark enough, and motion is detected. If you turn the switch off and on within a second or so, the light will stay on, and this overrides motion detection. To go back to normal operation, turn the switch off and wait 10 seconds, then turn back on. I believe most will also go back to normal operations after some hours, or after the sun comes up again It is possible that you'll damage the electronics by overriding the detector.
The safe way to do this would be to use a relay. I have this rig and I love it.
That is to say either the motion sensor can run the outdoor sconces OR the light switch. I made choice that there were too many people to train on the 'blink the switch' method of overriding the sensor. Yes You can 'jump' the sensor with a switch. Remember that the sensor requires a dedicated neutral for its electronics. You can also use this method to allow the two sensors to operate the same light.
I'd have to think about it logically before putting two sensors and a switch. It would work, but i'd draw a schematic for reference. This is called parallel. – Jan 10 '12 at 3:37.